![]() ![]() I am not sure you guys have time to help but your support in any way will be highly appreciated. How are these offsets calculated using the formula mentioned above? Plant Battery Voltage Register Offset: 0-1 if i got this right, why are some offsets mentioned like this: (Data Address = Pagenumber x 256 + Register offset). this is the formula mentioned in the manual In the DSE manual it says that a formula is used to get the data address. Does any one here have a sample project on TIA13 which is programmed to read for example the DC voltage on the DSE controller "Plant battery voltage" using Modbus? I am planning to use this as a reference to figure out how this is done correctly. Am stuck with the Modbus part, i can't figure out how to get for example the data like the "Plant battery voltage" from the DSE controller to the PLC. My plan is to read data from a genset controller that i have (DSE 8610) via Modbus. ![]() I got a S7-1200 CPU (1215C) with the RS485 communication module (CM1241). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |